Installation - Defiant DFI-5998-BK Guía Para El Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

1
Determining the mounting
location
NOTE: The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture is
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
Determine the mounting location – wall mount
only.
Position the lamp heads (A) in the general
direction of the desired light coverage.
2
Drilling canopy holes
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
Remove the existing light fixture.
Determine which of the four knockouts need to
be drilled to match the mounting holes on the
junction box.
Drill the necessary holes into the light
fixture canopy (B) using a drill (not included)
and a 3/16" (5 mm) drill bit (not included).
B
Wall Mount
3
Wiring the light fixture
Route the light fixture wires through the large
hole in the gasket (DD).
Connect the light fixture (B) wires to the
junction box wires with wire connectors (AA):
White to white
Black to black
AA
5
Please contact 1-866-308-3976 for further assistance.
A
UP
DD
HOMEDEPOT.COM
B

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1002366420

Tabla de contenido