Mounting The Light Fixture; Operation - Defiant DFI-5998-BK Guía Para El Uso Y Cuidado

Installation (continued)
4

Mounting the light fixture

□
Align the drilled holes on the light fixture
(B) with the holes on the junction box and
gasket (DD).
□
Secure the light fixture (B) to the junction box
using the mounting screws (BB or CC) that
best fit the junction box. Do not overtighten.
NOTE: Make sure all the wires are inside the junction box
before attaching the light fixture (B) to the junction box.
DD

Operation

1
Adjusting the lamp heads
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
□
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
B
BB or CC
5
Caulking around the light
fixture
IMPORTANT: Failure to completely caulk around the gasket (DD)
and the light fixture (B) could lead to water damage and is not
covered under warranty.
□
Caulk around the gasket (DD) and mounting
surface with silicone sealant (not included).
□
Caulk around the light fixture (B) and gasket
(DD) with silicone sealant (not included).
6
DD
A
B