Functional Description; Technical Specifications - Bosch FPP-5000-TI13 Instalación

14 en | Functional Description
1

Functional Description

The FPP-5000-TI13 LSN Communication Interface is an extension for the FPP-5000 External
Power Supply Unit Kit only. It is the communication interface between the FPP-5000 and the
panel, and transmits the following faults to the panel:
–
–
–
–
–
–
Additionally, with the FSP-5000-RPS programming software, the switching outputs can be
programmed and the settings for the line monitoring according to EN 54-13 can be done.
The module is plugged next to the BCM-0000-B on the PRS-0002-C Panel Rail Short and is
power-supplied by the panel rail via the module bus (MOB). The module's front side shows 4
LEDs, which indicate the operation and fault status.
2 Terminal Assignment and LED Displays
See Graphics, page 4.
Labeling
+U/0V
a1-/b1+
SHIELD
a2-/b2+
Labeling
STATUS
BCM 24V
3

Technical Specifications

See Graphics, page 4
2016.04 | 5.1 |
Mains fault
Battery fault
Battery internal resistance fault
BCM-0000-B Battery Controller Module fault
Short 24 V outputs
Ground fault
LED on
In operation
– Creeping
short
detected
1
– Over current
=> POWER
OUT1
switched off
Connection
1x auxiliary power supply incoming (connection terminals for
looping through)
1x auxiliary power supply outgoing (connection terminals for
looping through)
LSN incoming
Shield wire
LSN outgoing
LED off Labeling
Idle
GROUND
FAULT
No faults
BCM 24V
2
Installation
LSN Communication Interface FPP-5000
LED on LED off
Ground fault No ground
detected fault
– Creeping No faults
short
detected
– Over current
=> POWER
OUT2
switched off
Bosch Sicherheitssysteme GmbH