LG GoldStar WG5005 Manual Del Propietário página 18

Operating Instructions
_ CAUTION: The Remote Controller will not function properly if strong
light strikes the sensor window of the air conditioner or if there are
obstacles between the Remote Controller and the air conditioner.
Power
To turn the Set ON, push the button. To turn the Set OFF, push the button again.
This button takes priority over any other buttons.
When you first turn it on, the Set is on the High cool mode and the temp. at 72 °F
Temperature Setting
This button controls the room temperature setting in a range between
60C'Fand 86°F in 1 increments.
Fan Speed
Pressing the Fan Speed button toggles between Low and
High speeds,
On/Off Timer
- Stopping Operation |
Each press of the button cycles through the options inthis order:
L
1 Hour 42 Hours-3 Hours-4 Hours-5 Hours--6 Hours-7 Hours
48 Hours-9 Hours-lO Hours-11 Hours-12 Hours-CANCLE.
The set temperature will be raised by 2" F after 30 minutes and again
after another 30 minutes.
- Starting Operation
Each press of the button cycles through the options inthis order:
1 Hour_2 Hours-3 Hours-4 Hours-5 Hours-6 Hours-7 Hours
48 Hours-9 Hours-lO Hours-11 Hours-12 Hours-CANCLE.
Cool/Energy 8averlFanlDry
Everytime you push this button, it will toggle between COOL,
ENERGY SAVER, FAN, and DRY.
Fan Speed
Timer Mode
4 ......
Energy Saver
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
How to Insert Batteries
1. Remove the cover from the back of the remote
controller
2. Insert two batteries.
Be sure of the polarity when installing the
batteries.
Be sure that both batteries are new.
3. Re-attach the cover.
@
®
®
Do not use rechargeable
batteries. Such batteries
differ from standard dry cells
in shape, dimensions, and
performance.
Remove the batteries from
the remote controller if the air
conditioner is not going to be
used for an extended length
of time.
18 Room Air Conditioner