Uniteck UNIMPPT 60/15.24 Manual Del Usuario página 25

INSTALLATION - MOUNTING
has been designed for an indoor use.
UNIMPPT
It incorporates an external temperature sensor which adjusts the load voltage according to the ambient
temperature for an optimal load. It is recommended to instal the device near the battery.
The device has to be mounted on a solid, stable and dry appropriated flat surface.
Standard wiring
Cables exit via the 2
orifices in the cover
Wiring through a wall
Cables go through a
partition wall
To provide the required air circulation needed for cooling the solar charge controller, leave a 5-cm free
space (minimum) all around the device.
 Break the 2 caps of the cover
with pliers
 Break the cap of
5cm
www.uniteck.fr
5cm
5cm
5cm
EN
 Close the cover by
pushing upwards
 Close the cover by
pushing upwards
25/59