Viper LSU135 El Manual Del Propietario página 10

Wet And Dry Vacuum Cleaner
English
Clean the tank, do not let it stand for a long time with dust or dirty water.
The cloth dust bag can be washed and must be dried again before re-use
The motor is built for maintenance-free operation and does not need any particular service.
The carbon brushes may need to be replaced due to normal wear and tear caused by using
the vacuum cleaner over time, and they can be replaced only by our authorized service
centers.
WARNING
As with all electrical equipment care and attention must be exercised at all times during its use,
in addition to ensuring that routing and preventative maintenance is carried out periodically in
order to ensure its safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the
correct standard could render this equipment unsafe and he manufacturer can accept no
responsibility or liability in this respect.
WARNING
The following material must not be picked up by the vacuum cleaner:
hazardous dust, hot materials(burning cigarettes, hot ash ,etc.), flammable,
explosive, aggressive liquids(e.g. Petrol, solvents, acids, alkalis ,etc.), flammable explosive
dust(e.g. magnesium or aluminum dust, etc.)
IMPORTANT： ： ： ： If the socket outlets are not suitable for the plug
supplied with the appliance. It should be cut off and an appropriate plug fitted. The wires in this
main lead are colored in accordance with the following code.
Blue-Neutral Brown-Live.
As the colors of the wires in the mains lead of this appliance may not correspond with the
colored markings identifying the terminals of the plug proceed as follows. The wire, which is
colored blue, must be connected to the terminal, which is marked which the letter N or colored
black. The Wire, which is colored brown, must be connected to the terminal, which is marked
with the letter L or colored red.
The manufacturer reserves the right to modify the machine and the included accessories
without prior notice.
Wiring diagram refer to page6 and page7"Figure7/figure8/Figure9.
Product Specification Parameter, Product Specification can be referred to Page 7 "Form1".
１０