Keys And Their Functions - ratiotec Soldi Smart Pro Manual De Instrucciones

Operation
Switch ON and OFF
To switch on, press ON/OFF as long as an acoustic signal arises . When the device is switched on,
it will carry out a self-test and 0 will appear in the display .
Insert banknote
Place banknote on feeder: the device starts up automatically and pulls in the banknote . Euro-
banknotes can insert in any direction . Other currencies may have different directions . For further
information contact ratiotec or your sales representative .
False or suspect note
An acoustic signal arises and the red warning symbol blinks in case of a false or suspect note .
Additionally, an error message appears in the display . In the event of a false or suspicious bank-
note, the ejection is always against selected direction .
Note: If TONE or LED is switched off in Setup, no acoustical or optical signal will appear .

Keys and their functions

REP/ADD-switch (Report and addition function)
Press REP/ADD once to change to the report view . The frame lights up with blue light . The quan-
tity and value of all counted notes will appear with each pressing REP/ADD . Please note, only the
currently chosen currency appears . After the report the total value is displayed again .
Note: The report function is only available while the addition function is switched on .
Keep REP/ADD pressed for long to switch the addition function on or off . Is the function acti-
vated, the unit number and value number of the banknotes is automatically counted . The unit
number can be a value of up to 999 and the value number up to 9995 . After this, the display is
automatically reset to zero .
CURR/Setup-Taste (Currency- and Setup function)
Press CURR/Setup once to select the currency . The chosen currency is displayed . The Soldi Smart
Pro can detect up to three currencies, for further information contact ratiotec or your sales re-
presentative .
Keep pressed CURR/Setup down for several seconds to select the SETUP menu . The message
SETUP will appear and the frame lights up with blue light . To select the desired function, press
REP/ADD or CURR/Setup and change this by pressing ON/OFF .
4 5