Problem Identification - GGP ITALY Cruiser 430 Li 80 Serie Manual De Instrucciones

Operation
General cleaning and inspection
Checking for any damage to the
machine. If necessary, contact the
authorised assistance centre.
Complete bolt and screw check
Cleaning the air filter
Drive adjustment
Replacing the cutting-means
* Refer to the battery/battery charger manual.
** Operation to be performed at the first signs of any malfunction
*** The operation must be carried out by your Dealer or a specialised Service Centre

14. PROBLEM IDENTIFICATION

PROBLEM
1. The motor does
not start when the
switch is pressed
2. The motor shuts
down whilst working
3. The motor stops while
working and the machine
alarm buzzer is triggered
If problems persist after having performed the above operations, contact your dealer.
Frequency
(hours)
After each
use
After each
use
After each
use
Once a
month
**
-
PROBABLE CAUSE
Safety key is not inserted or is inserted
incorrectly
Battery is not inserted or is
inserted incorrectly
Low battery
Motor start-up is slow
The thermal protection has tripped
due to overheating of the motor
Battery is not inserted correctly
Low battery
Obstructions that prevent
rotation of the cutting means
The thermal protection has tripped
due to overheating of the motor
Thermal protection has tripped due to
excessive current absorption caused by:
• excessively high grass cutting
• obstructions that prevent
rotation of the cutting means
• too much grass debris accumulated in
the chassis and discharge channel
Completed (Date or Hours)
Insert the key (par. 6.3)
Open the hatch and check that the battery is
fitted into its housing correctly (par. 7.2.3)
Check the battery status and recharge if
necessary
. (par. 7.2.2)
Press and hold the control lever
for 1-3 seconds (par. 5.2)
Wait for at least 5 minutes and then restart
the machine
Open the hatch and check that the battery is
fitted into its housing correctly (par. 7.2.3)
Check the battery status and recharge
if necessary. (par. 7.2.2)
Remove the safety key, put on your work
gloves and remove any grass remains
or debris from the lower part of the
machine and/or the discharge channel
Wait for at least 5 minutes and then restart
the machine
• Set a higher cutting height when the
grass is very tall, then set a lower height
and cut the lawn again (par. 7.2.1)
• Remove the obstructions (par. 7.3.1)
• Clean the machine (par. 7.3.1)
Wait for at least 5 minutes and then restart
the machine
EN - 11
Notes
par. 7.3
-
par. 7.4
par. 7.3.3
par. 8.2
par. 8.1
***
REMEDY