Problem Solving - Philips SBCSC464/84 Modo De Empleo

Problem
Power light does
not light
High pitched noise
No sound
Power lights red
Interference or poor
reception
Pick-up from another
baby monitor
System check light
flashing (green) /
System check alarm

Problem solving

Possible cause
Parent Unit: unit is not turned on.
Power adapter is not plugged in or
batteries are exhausted.
Baby Unit: unit is not turned on.
Power adapter is not plugged in or
batteries are exhausted.
Units are too close together.
Volume on Parent Unit is set too low.
Batteries are low or empty.
Mobile or cordless phones too close.
to the baby monitor.
Both systems are operating on the
same frequency.
Units are out of range or there is
interference from another
FM source.
Baby Unit: unit is not turned on.
Hereby, Philips Consumer Electronics, B.U. Peripherals & Accessories,
declares that this SBC SC464 is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
ENGLISH
Solution
Turn VOLUME ON/OFF control
downwards.
Plug in power adapter or replace
batteries.
Push power button.
Plug in power adapter or replace
batteries.
Move Parent Unit away from Baby Unit.
Turn VOLUME ON/OFF control on
Parent Unit upwards.
Turn VOLUME ON/OFF control
downwards.
Replace batteries or connect to mains
power.
Move phones away from the units.
Switch channels.
Move units closer together to restore
the link. Remove the other FM source.
Push power button.
9