Electrolux EUF10003W Manual De Instrucciones página 15

Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the
cabinet.
If the cabinet is placed in a corner and the side
with the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at least
10 mm to allow the door to open enough so that
the shelves can be removed.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
1. Remove the plug from the power socket.
2. Tilt back the appliance carefully so that the
1
compressor cannot touch the floor.
3. Unscrew both adjustable feet.
2
4. Unscrew the screws of the door bottom hinge.
5. Take off the appliance door by pulling it slight-
ly downwards.
6. Unscrew the top door hinge pin of the appli-
ance then screw it back on the other side.
7. Fit the appliance door on the upper door
hinge pin.
8. Remove the lower hinge. Put over the pin in
the direction of the arrow.
9. Unscrew and install the screw on the oppo-
site side.
electrolux 15