Electrical Connections; Configuration; Biasi Connect" Installation; Module Wfc01" Configuration - Biasi Connect Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Electrical connections

With BOX not powered:
connect OTM terminals of the "Module WFC01" to
TA terminals of the boiler (see the Wiring Diagram
in the boiler's booklet);
connect OTS/TA terminals of the "Module WFC01"
to "OT" no. 1-2 terminals of the Remote Control
(see paragraph 1 of its booklet)
Terminals
NTC
Not used The external temperature
probe, if present, must be connected to
the
boiler's
temperature probe is integrated in the
Remote Control
OTM
Signal connection to the boiler
OTS/RT
Signal
connection
control
+24Vdc
Connector for power supply unit
Never connect any of the mentioned connections to
230V power supply.
Insert the power supply unit connector (supplied with
the kit) in the "Module WFC01" and connect the power
supply unit to a socket to power everything up.

Configuration

Required material:
"Module WFC01" powered and connected
Modem/router with Internet connection and
active WIFI network, functioning and stably
receivable at the installation point of the "Module
WFC01"
Android smartphone or iOS device with "BIASI
Connect" installed
Operation phases (preliminary summary):
in the first configuration phase of the "Module
WFC01", the BOX itself creates a temporary
Hotspot, namely it generates a WiFi network to be
used only for:
entering, by means of the smartphone and
o
"BIASI Connect", the credentials of your WiFi
network (that will be used by the "Module
WFC01" during its operation)
choosing a password to allow smartphones
o
(yours and any other one) to access the
control functions of boiler and system
board;
the
ambient
to
the
remote
P a g _
then, the Hotspot of the "Module WFC01" is
disabled and the communication between the
smartphone and "BIASI Connect" Kit occurs via
WEB and through your WiFi network

"BIASI Connect" installation

Install the "BIASI Connect" suitable for your operating
system (from Google Play Store o Apple App Store, see
also APP compatibility on page 11)
N.B.: During the installation and use, the APP could ask for acceptance
of conditions, and permission to access to some contents and functions
of your device.

"Module WFC01" configuration

When the "Module WFC01" is powered for the first time,
it automatically generates its own WiFi network
(Hotspot), that can be found among the WiFi sources
available from the smartphone and is identified by the
name of:
BP_WFC_OEM_APXXXXXX
(where the last 6 digits are the same 6 digits of the MAC
address of the device (without [:]), included on a label
partially visible from the window)
on your smartphone, with active WiFi, access
Settings > Wireless and networks (or similar,
depending on the system and version)
search for the name of the Hotspot transmitted by
the
"Module
smartphone to it. No password is required. The
indication "Internet may not be available" or
similar is normal, since it is an internal network
In the case you cannot see the Hotspot name in
the list, try to:
move your smartphone closer to the "Module
o
WFC01"
perform a total reset of the "Module WFC01"
o
(see "Module WFC01" total reset on page 14)
Start the "BIASI Connect"
o
If, at this point, you are adding a "Module
o
WFC01" on a smartphone which already
features other "Module WFC01", go to
paragraph Adding a "Module WFC01" on
page 13
12 | 36
WFC01"
and
connect
your

Publicidad

Tabla de contenido
loading

Tabla de contenido