Alarms; Boiler's Alarms; Kit-Related Alarms: E91 - E94 - Biasi Connect Manual De Instrucciones

•
"Enable device" sets, without any other step
necessary, a 24-hour default time;
•
"Activate device timing" allows setting a time
interval from 00h30' to 124h30' in steps of 30
minutes +/–:
•
"Enable device" sets, without any other step
necessary, a 24-hour default time starting from the
moment the command is given;
•
"Cancel timing"
immediately controlled by the Remote Control
again;
•
"Activate device timing" allows setting a different
timing starting from the current moment
At the end of activation time, the button
.

Alarms

Boiler's alarms

If the system "Module WFC01" Kit - APP - Remote Control
is working, the APP will show the symbol
drop-down menu. By clicking it, the alarm code "E..."
will show, with a short description and some instructions.
forces the system
on the side
On the boiler's handbook you'll find a dedicated
paragraph and a table that lists the possible alarms
and relevant, more detailed instructions.
We suggest you to read it and to call the Assistance
Service whenever you have difficulty solving the
problem with the procedures reserved for the User.
Note: as in all cases of malfunctioning of any device,
to be
the alarms provide an indication of the most probable
cause (to be investigated first) but not exclusive of
other problems, to be fixed by the Technician.

Kit-related alarms: E91 - E94

In case of failure of the system Kit BOX WFC - APP -
Remote Control, the APP will show the symbol
the side drop-down menu. By clicking it, one of the
alarms listed below will show, with a short description
and some instructions.
is again
E91 This alarm showing on the APP can be triggered by
different causes. Please, look at the boiler's
display and read the alarm code shown on it:
•
if the alarm E91 is present on boiler's display too,
means that the error is specific to the boiler and
therefore it is necessary to refer to its instruction
booklet
E94 This alarm showing on the APP can be triggered
by different causes. Please, look at the boiler's
display and read the alarm code shown on it:
if no error code is displayed on the boiler, the problem
is probably located on the link (interrupted or subject
to noise) between the "Module WFC01" and the
Remote Control (see also Electrical connections on
page 12). In case of interruption, the Remote Control's
display should be off;
P a g _ 17 | 36
on