Tabla de contenido
Publicidad
2. Torque adjustment ring
3. Gear selector
4. Direction of rotation selector
5. Trigger switch
6. Handle, insulated gripping surface
7. LED light
8. Battery pack
9. Belt clip
Intended Use
The hex driver is intended for fastening and removing screws and
bolts.
For damage caused by usage other than intended, the user is
responsible.
Symbols
Read all safety warnings and all instructions.
Warning
V
Volts
Direct current
No-load speed
CE conformity
EurAsian Conformity Mark
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Battery
A battery that is new or has not been used for a longer period does
not develop its full capacity until after approx. 2 – 3 charging/
discharging cycles.
Do not place down the battery on radiators or expose it to intense
sunlight for longer periods; temperatures above 50 °C cause damage.
Keep the contacts/terminals of the charger and replaceable battery
clean. For optimal service life, fully charge the battery after use.
Dust Extraction
Dusts from materials such as lead-containing coatings, some wood
types, minerals and metal can be harmful to one's health. Touching
or breathing-in the dusts can cause allergic reactions and/or lead to
respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered carcinogenic,
especially in connection with wood-treatment additives (chromate,
wood preservative). Materials containing asbestos may only be
worked on by specialists.
Provide for good ventilation of the working place.
being worked on.
Maintenance and Cleaning
Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
changing accessories or storing power tools. Such preventive
safety measure reduce the risk of starting the power tool
accidentally.
For safe and proper working, always keep the product and
ventilation slots clean.
If the product should fail despite the care taken in manufacturing and
testing procedures, repair should be carried out by a Würth master-
Service.
In all correspondence and spare parts orders, please always include
the article number given on the type plate of the machine.
The current spare parts list for this power tool can be viewed in the
Guarantee
For this Würth power tool, we provide a guarantee in accordance
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or improper handling is
excluded from the guarantee.
Claims can only be accepted if the power tool is sent undisassembled
customer service agent for Würth compressed-air and power tools.
Disposal
The product, accessories and packaging should be sorted for
environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According to the European Guideline 2012/19/
EU for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.
Noise/Vibration Information
Measured sound values determined according to EN 62841.
Typically the A-weighted noise levels of the product are: Sound
pressure level 67.0 dB(A); Sound power level 78.0 dB(A). Uncertainty
K=3 dB(A).
Wear hearing protection!
according to EN 62841:
Vibration emission value ah = 0.4 m/s
(Screwdriving)
The vibration emission level given in this information sheet has been
measured in accordance with a standardised test given in EN 62841
, uncertainty K=1.5 m/s
.
2
2
15
Publicidad
Tabla de contenido
