Attach Back Panels - Gladiator GALG36CKXG Instrucciones De Ensamblaje

1b.
Attach Side Panels
F1 5/16" Allen-head bolt (12)
Turn the cabinet onto its side and fasten the two bolts at each
front corner of the cabinet frame. Using the Allen wrench
(provided), completely tighten all 16 cabinet bolts.
4
F1
P1
P2
P1
2.

Attach Back Panels

F3c
F3c Phillips-head screw (32)
P8
P1
P9
P10
P1
P3
IMPORTANT: Attach the back panels starting at the top of the
cabinet with back panel (P8) and working down to the cabinet
bottom. Each back panel will overlap the panel below. Align the
tabs in back panel (P8) with the loops in the top (P2) and sides
(P1) of the cabinet. Slide back panel (P8) toward the cabinet top
(P2) until the back panel is firmly in place.
NOTE: Make sure each tab is inserted fully behind the loop as
shown. Slide back panel (P9) upward until the top of panel (P9)
is under back panel (P8) and the tabs are inserted in each loop.
NOTE: Each back panel will slightly overlap the panel below.
Repeat Step 3 to assemble the remaining back panels ending
with back panel (P10). Using Phillips-head screws, attach each
back panel to the panel below. Using Phillips-head screws, attach
panel (P8) to the cabinet top (P2) and panel (P10) to the cabinet
bottom (P3). Completely tighten all back panel screws starting
with the sides and continuing with the top, middle and bottom.
P8
P9
P9
P2
P1