Kathrein DVB-S(2)-COFDM Manual Del Usuario página 18

1.3 DiSEqC setting
TM
The DiSEqC TM controller for a matrix can be set in the sub-menu for the input socket that was selected.
Press the "Sub-menu" button
1236
E1
27.500 MS/s
Outp. S21
8 MHz
Select the desired level using the "+" and "-" buttons. The following settings are available:
DiSEqC -A or -B
TM
Note: When the DiSEqC
If no matrix is used, the DiSEqC
The DiSEqC TM controller can be set up only in the sub-menu for the input tuner 1 (E1). The selected information available in the
sub-menu for the input tuner 2 (E2) is displayed solely for information. It cannot be selected there. The DiSEqC
to both E1 and E2. Each of inputs A and B can be plugged into either input tuner.
1.4 Selecting input frequency
The input frequency in the active channel unit is selected using the "<" and ">" buttons. The input frequency can be set continuously
from 950 MHz to 2150 MHz in 1 MHz steps using the "+" and "-" buttons.
E1
1236
27.500 MS/s
Outp. S21
8 MHz
The setting can also be made on a digit-by-digit basis:
• Press the "Change setting mode" button
• The fi rst digit fl ashes and can be input directly using the numeric pad on the keyboard
• After the fi rst digit has been input, the second fl ashes, and so on
• To make a correction, press the "Back" button to skip one place to the left
• After the last digit has been set, press the "Change setting mode" button
The current SNR and the automatically detected operating mode, DVB-S or DVB-S2 of the front end are displayed in the input
frequency sub-menu.
Press the "Sub-menu" button
to activate the sub-menu; press the "Sub-menu" button
MHz
3/4
306.00
QAM64
Main Menu
off The DiSEqC
Ver-Low-1 In connection with a matrix: Vertical low band position 1
Hor-Low-1 In connection with a matrix: Horizontal low band position 1
Ver-High-1 In connection with a matrix: Vertical high band position 1
Hor-High-1 In connection with a matrix: Horizontal high band position 1
Ver-Low-2 In connection with a matrix: Vertical low band position 2
Hor-Low-2 In connection with a matrix: Horizontal low band position 2
Ver-High-2 In connection with a matrix: Vertical high band position 2
Hor-High-2 In connection with a matrix: Horizontal high band position 2
controller is switched on, a DC voltage of approx. 12 V is present at the input sockets!
TM
controller cannot be switched on.
TM
MHz
3/4
306.00
QAM64
Main Menu
(starts the mode)
to activate the sub-menu; press the "Sub-menu" button
TP ***
QPSK Input
MHz DiSEqC-A
DiSEqC-B
controller is switched off
TM
TP E1
QPSK 27.500
MHz Outp.
8
Main menu (example for digit-by-digit setting)
to end the mode.
4 / 14
again to deactivate it.
UFO333MX
A
Off
off
Sub-menu for channel unit I
MHz
1236
MS/s 3/4
S21 306.00
MHz QAM64
again to deactivate it.
***
controller applies
TM
TP
QPSK
MHz