Attach Intermediate Tube And Con- Centrator Nozzle; Starting / Stopping Instrustion; Adjust Back Pack Harness And Control Handle - Troy-Bilt TB25BP Manual Del Operador

ATTACH INTERMEDIATE TUBE AND CON-
CENTRATOR NOZZLE
Connect the intermediate tube (H) and concentrator noz-
zle (I) or 56mm nozzle (J) (you can only use I nozzle at
time). Push the tubes together and turn them clockwise
so that they lock together (Fig. 7). Use concentrator noz-
zle when you need more airflow in tight places: flower
beds, under decks, etc.
B
D
STARTING A COLD ENGINE (Above 55˚F)
Mix the bottle of 2-cycle oil (included) with 1 gallon of unlead-
ed gasoline (less than 30 days old). Combine them in a sep-
arate container using a 40:1 ratio. Pour into fuel tank.
1. Squeeze throttle (A) and push throttle lock (B) to
advance throttle for starting. (Figure 9)
2. Pump "primer bulb" (C) 10 times. (Figure 10)
3. Move choke lever to Choke "1".(Figure 11)
4. With the unit on the ground, hold the top assist handle
and step on the bottom of the frame with foot. Pull
starter rope 3 times. (Figure 12)
B
A
ASSEMBLY INSTRUCTIONS
H
40mm
J
Fig. 7
STARTING/STOPPING INSTRUCTIONS
Fig. 9
ADJUST BACK PACK HARNESS AND
CONTROL HANDLE
1. Place blower on your back by slipping arms through
the shoulder straps as if you were putting on a jacket
(Figure 8).
2. Adjust backpack harness and control handle.
3. Once adjustments have been made, to the straps
for user comfort, remove the blower from your back
and place on level ground in an upright position.
I
56mm
10
Fig. 8
C
Fig. 10
D
Fig. 11