Care And Maintenance - allen+roth S17VBCU4218 Manual De Instrucciones

PACKAGE CONTENTS
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or
install the product.
WARNING
Do not stand on vanity. Use vanity on level ground. Base vanity supports a maximum weight of 200
lbs. Exceeding maximum weight limit will compromise the integrity of the vanity structure and could
cause the vanity to fail.
CAUTION
Do not hang from the vanity.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Installation Time: 30 minutes
Tools Required for Installation (not included): #10 x 2-1/2 in. Installation Screws, Phillips Screwdriver,
Drill, 3/32 in. Drill Bit, Marking Tool, Carpenter's Level, Tape Measure and Stud Finder.
INSTALLATION INSTRUCTIONS
STEP 1: Wall Stud Location
It is recommended this item be installed to at least 1 wall stud. Use a stud finder
(not included) to find the wall stud(s) at the desired installation site and mark
area(s) with a pencil (not included). Note: To make installation easier, remove
door(s) from the vanity before installation.
A
B
PART DESCRIPTION QUANTITY
A Vanity Top
B Vanity Base
1
Lowes.com/allenandroth
2
INSTALLATION INSTRUCTIONS
STEP 2: Vanity Drawer Removal (if applicable)
2a. Open the preassembled drawer as far as possible.
2b. Simultaneously press the right side spring clip downward
and the left side spring clip upward.
2c. Once both springs clips are held in the indicated position,
pull the drawer straight out.
STEP 3: Vanity Base Installation
3a. Place vanity base (B) at the desired position.
3b. Drill through vanity back braces into wall studs using a 3/32
in. diameter drill bit (not included). Note: Holes should
come no closer than 2 inches from any inside edge.
3c. Insert installation screws (not included) through vanity base (B)
and into the holes and tighten securely.
3d. Install knobs (AA) to the door(s) with the preassembled hardware.
1
STEP 4: Vanity Drawer Installation (if applicable)
1
4a. Close completely both slides attached to the vanity base (A).
4b. Move the component of the slides with ball bearings to the
front of the slides, still keeping the slides completely closed.
4c. Carefully line up the slides of the drawer box with the
slides in the vanity base (A) and push the drawer all the
way to the back.
4d. Open the drawer completely to ensure it is properly installed.
STEP 5: Hinge Adjustment For Door Alignment
If the alignment of the preassembled doors on vanity base (B) is
off, refer to the figure on the right for how to adjust them.

CARE AND MAINTENANCE

Vanity
Use non-abrasive cleaners and/or cleaning agents that do not contain solvents.
Vanity top
Clean the surface with a glass cleaner or other household cleansers that do not contain chlorine.
Avoid using abrasive cleaners as they will damage the surface.
ONE-YEAR LIMITED WARRANTY
The following is a general summary of what the full Limited Warranty includes, excludes and other
important limitations and disclaimers. For a full statement of the Limited Warranty, including all
exclusions, limitations and disclaimers, call 1-866-439-9800.
®
2
Simultaneously
press the right
spring clip
and left spring
clip to remove
drawer
3
B
4
5
Adjust gaps between
doors and vanity
Adjust door height
Adjust damping force
Adjust gaps between doors
Lowes.com/allenandroth
3
Drill through
cabinet back
braces
®