Torqeedo 1966-00 Manual De Instrucciones página 10

1. Important information
The Display Gateway enables Torqeedo system data to be displayed on NMEA 2000
patible display devices. The display data currently transmitted (see Chapter 3) correspond
to the current possibilities of the standard. In the event of future extensions to the stan-
dard, these will be made available through a software update. Contact your Torqeedo part-
ner. Only data from Torqeedo components can be displayed using the Display Gateway.
This product requires no maintenance. To clean it use only a soft cloth and mild deter-
gents that are compatible with plastic materials (e.g. washing-up liquid). Do not use any
chemicals or solvents. Always use the latest version of the operating instructions.
You can find these and further information at www.torqeedo.com.
2. Assembly
- The Display Gateway, as shown on pages 4 and 5, is connected to the TorqLink
Backbone at any point using the supplied T-cable (connector A).
A: TorqLink Motor with TorqLink throttle
B: TorqLink Motor with aluminium throttle
C: TQ-Bus Motor with Power 48-5000
D: TQ-Bus Motor with Power 24-3500
E: TorqLink Twin-System
F: Power 48-5000 Power-Bank
1. Cruise with TorqLink
1a. Port Motor
1b. Starboard Motor
2. Charger or fast charger
3. Power 48-5000 (2 x with Cruise 10.0)
4. Display Gateway Single
4a. Display Gateway Twin Port
4b. Display Gateway Twin Stb.
5. TorqLink throttle (1976-00)
6. NMEA 2000 feed
with fuse + switch
7. NMEA 2000 Display
8. NMEA 2000 Termination
*
NMEA 2000 is a registered trademark of the National Marine Electronics Association.
10
9. Aluminium throttle
(1949-00, 1950-00, 1951-00)
10. TorqLink Terminator Single
11. Emergency stop
12. I/0 switch
13. Cruise without TorqLink (TQ-Bus)
14. TorqLink Gateway
15. Remote throttle (1918-00)
16. Emergency stop bridge
17. Power 24-3500
18. Double throttle (1952-00)
19. TorqLink Terminator Twin
20. Key switch
com-
*