English
Your new Philips Volume Styler is specially designed to give beautiful styling results.
It is quick and easy to use. We hope you will enjoy using your Volume Styler - the
styler you can create volume curls and waves with.
In order to get the best results with the Volume Styler, please read the instructions
carefully before use. Also refer to the illustrations on fold-out page 3.
Important
• Before connecting the appliance check that the voltage
indicated on the type plate corresponds to the mains
voltage in your home.
• Do not use this product near water e.g. in baths, washbasins, sinks.
If ever the product has fallen into water: first unplug immediately. Then,
dispose of the product. It must not be used again.
• Always ensure that the attachments are completely dry (also on the
inside!) before affixing them to the styler.
• Always switch the appliance off before putting it down, even if it is only
for a moment.
• For additional protection the installation of a residual current device
(RCD) with a rated residual operating current not exceeding 30 mA is
advisable in the electric circuit supplying the bathroom. Ask your installer
for advise.
• Even when the appliance is switched off, the power is still on. Always pull
out the mains plug when not in use.
• Never obstruct the air inlet grille.
• This product is equipped with an automatic overheating protection
device. If the appliance overheats, it will switch off. Unplug the appliance.
After cooling down for a few minutes, the appliance can be used again.
Before reusing, check the air inlet grille for possible blockage by fluff,
hair, etc. If in doubt, consult your dealer or a Philips Authorised Service
Dealer.
• If the mains cord of this appliance is damaged, it must only be replaced
by Philips or their service representative, as special tools and/or parts are
required.
• For examination or repairs always return the appliance to a Philips
Authorised Service Dealer. Unqualified repair work can be dangerous for
the user.
4