Installation; Preparing For Installation - Glacier bay HD883X-0004 Guía De Uso Y Mantenimiento

Installation

1

Preparing for installation

CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Drill holes in the nished deck as shown in
the diagram below.
NOTE: This kit allows up to 1-3/4 in. deck thickness.
1-3/8 in.
Diamter
1-1/8 in.
Diamter
3
Removing the mounting kits
□
Remove the indexes (E). Loosen the screws (F)
and remove the handles (G).
□
Loosen the anges (H) from the valve bodys
(I & J). Adjust the rubber washers (K), metal
washers (L) and mounting nuts (M) to the
bottom of valve bodys (I & J).
1-3/8 in.
Diamter
1-3/8 in.
Diamter
1-3/8 in.
Diamter
2
Installing the spout assembly
□
Remove the preassembled mounting nut (D) and
washers (B & C) from the spout assembly (A).
□
Insert the spout assembly (A) through the hole
in the deck.
□
Secure the spout assembly (A) with the rubber
washer (B), metal washer (C) and mounting
nut (D).
B
C
D
E
F
G
4
A
E
F
H
I
K
L
M
J
K
L
M
G
H