Vacuum Cleaner; Handle Assembly; Cord Assembly - Kenmore 116.31069 Manual De Uso Y Cuidado

ii, i i i i
Please pay special attention to these hazard alert boxes, and follow any
instructions given. WARNING statements alert you to such hazards as fire, electric
shock, burns and personal injury. CAUTION statements alert you to such hazards
as personal injury and/or property damage.
ill ii
_IbWARNING
Electrical Shock Hazard
Do not plug into the electrical supply
until the assembly is complete, Failure
to do so could result in electrical shock
or injury.
Before assembling the vacuum cleaner_
check the PACKING LIST (page 2). Use
this list to verify that you have received
all the components of your new Kenmore
vacuum cleaner.
HANDLE ASSEMBLY
Remove the combination brush from the
handle to expose the handle mounting hole.
Remove the handle screw from the body
of the vacuum cleaner.
Position the handle assembly as shown in
the illustration below.
When installing the handle, firmly press
the handle onto the body. Secure with
handle screw provided,
Begin to tighten the screw with your
fingers. It may be necessary to adjust the
handle slightly.
Using a screwdriver, tighten handle screw.
Do not overtighten.
Reinstall combination brush.
Handle Electrical
Screw Connection
tom Here --
:;2biy
Combination |
Brush -_7 |
Handle Screw Here
_kCAUTION
Do no| overtighten.
Overtightenlng could strip the screw
holes.
Do not operate the vacuum cleaner
without the screw in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove the
wire tie from the power cord.
Quick
Release
Upper Cord
Power Cord
Plug
Lower
Cord Ho ok!
Carrying
Handle
Wrap the power cord around the quick
release cord hook and the carrying handle.
Lock the power cord plug onto the power
cord.