Light Bulb Replacement - Kenmore 116.31069 Manual De Uso Y Cuidado

I
WARN ING
LIGHT BULB REPLACEMENT
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
the vacuum cleaner suddenly starting.
TO REMOVE LIGHT BULB
4. Remove the light
bulb by pulling straight
out.
5. To replace the light
bulb carefully insert
See PARTS AND FEATURES for bulb
number Page 5.
I. Disconnect
Flat power cord
Screwdriver from electrical
outlet.
Headfight
Lens
,&_ CAUTION
2. Press handle
release pedal
and lay vacuum
cleaner back.
3. Pry light lens
out at slots
using fiat
screwdriver as
shown on both
sides. Rotate
lens up and lift
off.
I I I II I IIIIIIIII/
Do not use a bulb rated over 9W (13V),
During extended use, heat from the bulb
could overheat surroundingplastic parts.
_is CAUTION
Do notplug in or turn on until the vacuum
cleaner is completelyreassembled.
6. To replace light lens,
place tab at front of lens
into slot. Rotate lens
down and firmly snap
into place.
21