Milescraft ToolStand 1097 Manual Del Usuario página 2

Assembly
Tool Holder # (DPHEAD)
1
Remove stabilizer
sleeve and discard.
(used for
shipping only).
4
Screw Tool Holder
Adjusting Screw into
the Tool Sleeve Nut
7
Slide Tool Holder over Tower
and tighten Adjusting Screw
to hold in place
Base Plate #40012
Tower #40031
2
Insert Tower Nut into slot provided on
the underside of the base plate.
5
Screw Tool Holder
Adjusting Screw inserted
into Tool Sleeve Nut
8
Insert Tool Strap Bolt into
Tool Strap
(3) Screws #40351
Tower bolt #4002
Tower nut #4015
Tower cap #40041
-2-
(3) Washers #40351
(3) Base grommets #40341
Ring #36130
3
Insert Tower into
hole at end of Base
Plate, and tighten
Tower Bolt
6
Insert Tool Sleever Nut into
slot provided on the inside
of the Tower Sleeve.
9
Screw Retainer Bolt into
Tool Strap Bolt