ENER-J K10DW Manual Del Usuario página 12

10. Switch Pairing Method
• Ensure the receiver controller is connected to
100-250V AC and power is 'on'.
• Press the function button for 3~5 seconds, (the
indicator light will flicker slowly) then release the
button to enter the pairing mode.
• Press the "wireless switch" to be paired, when
the indicator light stops flashing, at this time the
indicator lights will come on or off with the press
of switch, indicating pairing a success.
• Repeat above steps to add multiple switches.
The receiver can store up to 20 switch codes.
• Repeat this process for each button on Double
and Triple switch.
Press button
for 3 seconds
11. Clear pairing
• Press the button for more than 6~7 seconds,
the indicator quickly flashes 10 times and at the
same time, the relay performs the turn-on/off
action quickly, this indicates all recorded codes
have been deleted.
Indicator(red)
Press to
complete the
code
11