Description Of The Device - EAS ELECTRIC EMR45 Guia De Inicio Rapido

DESCRIPTION OF THE DEVICE

1. Top hinge cover
2. Door bin
3. Bottle bin
4. Adjustable foot
5. Shelf
6. Tray
NOTE:The appliance design is subject to change without prior notice.
38
V.1
INSTALLATION
– Before turning it on for the first time, position the device in the desired location by
– two or three hours to allow your system to adapt to the place.
Do not locate nearby from heat sources, such as kitchens, boilers or indirect
sunlight, etc. Leave a space of 10 cm on the sides, the top and the back of the device
to allow good air circulation. The device has not been designed for embedded
installations.
– Install on a firm surface and smooth, any deformity in the floor must be corrected
prior to installation. If there is a slight slope, you can correct it by adjusting the front
legs.
NOTE:
If you have not installed the device on a firm surface, you must readjust the base using the
front legs, once it has settled. To prevent the device from tilting, the door support must be
placed on a flat surface, such as else floor, table, etc.
39
V.1