DWT ABS-12 CLi Manual De Instrucciones página 25

• The power tool could be put down only after the
parts of power tool is completely static� Accessory on
the power tool might be clamped during work, which
may make it difficult for you to control the power tool.
• Appropriate detector shall be used to find the
location of hidden power wires� Or you should obtain
relevant information from local power supply unit�
Drilling electric wires will cause fire and electric shock.
Damaged gas pipe will cause exploration� If water pipes
are punctured, damage will be caused to property�
• In case a accessory installed on the power tool
is clamped, you shall shut down the power tool and
stay calm� At that time, the power tool will produce
extremely high reactive torque thus resulting in return
stroke� The accessory installed on the power tool are
likely to be clamped, for example: hypercharge of
power tool or skewing of accessory installed on the
power tool during work�
• If hidden electric wires or power lines of the power
tool itself might be cut off during work, you must hold
the insulated handle to operate the power tool� When
the power tool is in touch with a charged line, the metal
parts on the power tool will conduct electricity and may
cause the operator to get an electric shock�
• During work, you must tightly hold the power tool
and ensure you stand firmly. You should hold the
power tool with your hands�
• When operating and using the power tool, you can
only hold switch position of the main handle rather than
other parts�
• Avoid stopping an power tool motor when loaded�
• Never remove any chips or fragments with your
power tool's motor running�
• Use accessories without defects - it will make work-
ing with the power tool easier�
• The modification of the drill bits design and the use
of removable orifices and accessories not envisaged
for this power tool is strictly forbidden�
• Do not apply excessive pressure when operating the
power tool - it can jam the drill bit and overload the engine�
• Do not allow drill bits to jam in the material pro-
cessed� If this occurs, do not try to release them by
means of the power tool engine� This can put the pow-
er tool out of order�
• Striking out drill bits jammed in the material pro-
cessed with a hammer or other objects is strictly for-
bidden - metal fragments can hurt both the operator
and the people nearby�
• Avoid overheating your power tool, when using it for
a long time�
Symbols used in
the manual
Following symbols are used in the operation manual,
please remember their meanings� Correct interpreta-
tion of the symbols will allow correct and safe use of
the power tool�
Symbol Meaning
Cordless drill /
screwdriver
Sections marked gray - soft
grip (with insulated surface)�
Symbol
English
25
Meaning
Serial number sticker:
ABS ��� - model;
XX - date of manufacture;
XXXXXXX - serial number�
Read all safety regulations
and instructions�
Wear safety goggles and ear
protectors�
Wear a dust mask�
Do not heat the battery
above 45°C� Protect from
prolonged exposure to direct
sunlight�
Do not dispose of the battery
in a domestic waste con-
tainer�
Do not dispose of the battery
in the fire.
Protect the battery from the
rain�
Battery charging time�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Attention� Important�