Faq And Troubleshooting - Corsair ONE Serie Manual De Instrucciones

FAQ/TROUBLESHOOTING
Q: My CORSAIR ONE will not boot.
A: Disconnect all cables from the CORSAIR ONE and hold the power button for 5 seconds.
Then reconnect the cables and attempt to power it on. If the unit still does
not boot, disconnect all cables from the CORSAIR ONE again and hold the Clear CMOS
button on the back of the unit for 15 seconds. Afterwards, reconnect the cables and try to
power on the system again.
Q: My CORSAIR ONE does not display a picture over DisplayPort.
A: Check the connection between the CORSAIR ONE and your monitor or monitor(s). Also
ensure that your display is on the correct input and the cable you are using is DisplayPort
certified.
Q: My CORSAIR ONE does not display a picture over HDMI, or motion in the image
is choppy.
A: Check the connection between the CORSAIR ONE and your monitor or monitor(s). Also
ensure that your display is on the correct input. Finally, try connecting with a different
cable. To ensure the best quality image, use an HDMI cable certified for HDMI 2.0
operation at 18Gbps.
Q: The Diagnostic Tool hangs.
A: Turn off any system scanning tools, including antiviral software, then open the Diagnostic
Tool again.
Q: Wi-Fi and/or Bluetooth is/are not working.
A: Make sure that the antennas on the back of the unit are connected and fully screwed
on. If they are attached properly and you still are not able to use Wi-Fi and/or Bluetooth
connectivity, contact CORSAIR customer support.
Q: Do I have to connect my keyboard and mouse in the 2 USB ports with the keyboard
and mouse icons?
A: No. You can connect your keyboard and mouse to any USB ports.
9