Magnat TEMPUS SUB 300A Manual Del Propietário página 10

THE ACTIVE SUBWOOFER MAGNAT TEMPUS SUB 300A
This subwoofer has been adapted to provide the best visual and acoustic match to the MAGNAT
TEMPUS range of loudspeakers. However, it goes without saying that it may be combined with other
loudspeakers.
When connecting your loudspeaker, please make sure that everything has been switched off.
Furthermore, make sure that all loudspeaker cables are connected to the proper poles, i.e. the
positive pole for the output is connected to the positive pole for the input and the negative pole with
the negative pole. Please also refer to your receiver's/amplifier's and loudspeakers' instructions.
POSITIONING
The frequency range reproduced by the subwoofer cannot be pinpointed by the human ear. That's
why positioning generally doesn't present any problems. However, it is preferable to place the
speaker close to the front loudspeaker in front of the listening position. You should also make sure
that the distance from the sides and from the rear to items and walls is at least 20 centimetres as
otherwise bass reproduction may be impaired.
THE SUBWOOFER'S OPERATING ELEMENTS (FIG. 1)
Mains connection (10)
The subwoofer is equipped with an integrated amplifier and needs to be connected to a mains outlet
by means of the supplied mains cable.
Operating mode switch (3), operating state LED (2), power switch (8)
Power switch ON
Operating mode Subwoofer is in permanent operation, the LED is
switch ON green.
Favourable setting for the reproduction of
programmes with long quiet passages (this prevents
the subwoofer from switching off unintentionally).
Operating mode The automatic switching on/off is activated
AUTO (recommended setting).
The subwoofer switches on automatically when it
receives a signal from the receiver, the LED turns
green.
It automatically switches to standby after receiving
no signals for some minutes, the LED turns red.
Line inputs (6)
For connecting to level outputs on a receiver/amplifier (stereo mode), see Fig. 2.
For connecting to an AV receiver with low-level subwoofer output, see Fig. 3.
High-level inputs (7)
For connection to the high-level (speaker) outputs of the receiver/amplifier, refer to Fig. 4.
10 10
Power switch OFF
The subwoofer is
switched off, LED is
off.
This is the setting
for when subwoofer
isn't used over long
periods.