Bürkle 5601-0400 Instrucciones Para El Uso página 5

Safe filling
1. Pull off the closing cap from the discharge tube.
2. Place the filling container under the discharge tube.
3. Activate the piston rod  by using the handle 
and fill off the liquid.
CAUTION!
A too heavy lateral load can deform the piston rod
and cause a leakage of the pump head.
` ` Move the piston rod up and down in a straight line.
Accessories
Typ
Antistatic set
Brass barrel screw joint
Gastight barrel connector
Discharge hose
Drain safety stand
More accessories can be found at www.buerkle.de
Troubleshooting
Problem
Liquid is not pumped.
Annex
Operational directive in accordance with 1999/92/EC:
Zone 0
Zone 1
Zone 2
Product directive in accordance with 94/9/EC:
Group I
Group II
Group IIA
Group IIB
Group IIC
Spezifikation
To prevent electrostatic charging
R2" steel fine outer thread
R2" steel fine outer thread
1.20 m, with stopcock
Total length 117 cm, Ø 35 mm
To eliminate the error
Bottom valve is polluted. Clean the pump.
If there is only little residual liquid in the container, the pumping must be carried
out for a longer time.
a potentially explosive atmosphere is assumed to be continuously present
a potentially explosive atmosphere is assumed to be occasionally present
a potentially explosive atmosphere is not anticipated (and if it does occur, then only
rarely and briefly)
for use in mining
for use in other areas subject to explosion hazard
Maximum permitted gap > 0.9 mm
0.5 mm < maximum permitted gap < 0.9 mm
Maximum permitted gap < 0.5 mm
CAUTION!
Fluid ejection off the filling container. Bodily injury
due to escaping liquid.
` ` Wear the necessary protective clothing.
Completing filling and dismounting
1. After the last pump stroke, leave the piston rod in
the lower position and insert it into the pump up to
the stop.
2. Carefully unscrew the instrument from the container.
3. Rinse the instrument with a pH-neutral fluid.
English
Anzahl Artikel-Nr.
1 5602-1000
1 5601-0100
1 5601-0130
1 5601-0090
1 5618-1000