Chamfering Edges; Using The Rip Fence; Using The Fold Depth Stop (See Fig. G); Removing/Replacing The Planing Blade - Parkside PEH 30 C3 Traducción Del Manual De Instrucciones Original

Chamfering edges

The V grooves in the front plane sole
easy chamfering of workpiece edges.
♦ Use the V groove that corresponds to the
chamfer width required.
♦ Place the planer with the V groove
workpiece edge and guide it forwards.

Using the rip fence

♦ To fit the rip fence, guide the connecting
screw through the connecting piece
8b
the rip fence .
♦ Place the washer
8c
screw .
8b
♦ Screw the lock nut
screw .
8b
♦ Fit the rip fence
the fastening screw
♦ Undo the lock nut
♦ Retighten the lock nut
♦ Ensure that the plane is applied with lateral
pressure.
Using the fold depth stop (see fig. G)
♦ Fit the fold depth stop
using the fastening screw
♦ Set the desired fold depth in millimetres using
the fold depth stop
♦ Repeat the planing process several times until
the required fold depth is achieved.
│ GB │ MT
■ 50
allow
onto the
8a
on the connecting
onto the connecting
onto the appliance using
.
and set the desired width.
.
onto the appliance
.
.
Removing/replacing the planing
blade (see figs. C–E)
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
CAUTION!
► There is a risk of injury due to the cutting
edges of the planing blade
► Never touch the planing blade
and
cutting edges.
The planing blade
can be turned.
♦ Replace the planing blade
edges are blunt.
♦ Do not try to sharpen the planing blade
Turn the planing blade
WARNING! RISK OF INJURY!
► Wear suitable protective gloves when changing
the planing blades.
NOTE
► Do not undo the two hex socket screws.
These are used for adjusting the height of the
cutter block. No adjustment is required if you
use the planing blades sold by the manufac-
turer. Use only the planing knives supplied by
the manufacturer.
► When changing the blade, always replace
both blades to prevent an imbalance.
► Unscrew only one blade to start with. This will
allow you to use the factory-mounted second
blade for reference when reassembling later.
♦ Use the supplied open-ended spanner
undo the 3 fastening screws
that the planing blade
(see fig. C).
♦ Push the movable cutter block guard
slot in the housing.
!
on its
has two cutting edges and
when both cutting
or replace it
a little way so
can be moved
into the
PEH 30 C3
.
to