Replacing The Drive Belt (See Fig. F); Maintenance And Cleaning - Parkside PEH 30 C3 Traducción Del Manual De Instrucciones Original

♦ Push the planing blade
clamping element
NOTE
► The planing blade
with protective lacquer. It is not necessary to
re-bond the blade.
♦ Fit either a new or turned blade in the reverse
order. Make sure that the notch on the planing
blade slides into the tensioning plate
groove (see fig. E).
20a
♦ Make sure that the planing blade
a little way (approx. 1 mm) from the cutter
block in the direction of the movable lateral
cutter block guard
block to check that the planing blade does not
touch anything.
♦ Also ensure that the clamping element
closes flush to the cutter block
element must contact the hex screws
before the fastening screws
ened.
♦ Planing blades can be purchased exclusively
from the address given below (see section
"Service"). Do not use planing blades from
other manufacturers.
Setting the planing blade height
♦ Set the cutting depth to 0 mm.
♦ Check the position of the planing blade
both ends. Use a flat, straight object as a guide
strip over the plane sole
♦ The tip of the planing blade
with the surface of the plane sole
♦ The height of the planing blade
adjusted using the hex key
screws
. Adjust the two hex screws
18a
the tip of the planing blade is flush with the
plane sole on both sides.
PEH 30 C3
sideways out of the
(see fig. D)
may be factory-bonded
protrudes
. Carefully turn the cutter
. The clamping
18a
can be tight-
at
.
must be flush
.
can be
via the two hex
so that
18a
Replacing the drive belt (see fig. F)
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
♦ Remove the screws
belt cover .
♦ Remove the worn drive belt
♦ Fit the new drive belt
wheel first and then turn the drive belt
and pull it onto the large belt wheel
♦ Replace the drive belt cover
place using the screws

Maintenance and cleaning

WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
♦ Keep the appliance and the ventilation slits
clean to ensure fault-free operation.
♦ Clean the chip ejector
♦ To clean a blocked chip ejector, use a suitable
tool (e.g. a piece of wood, compressed air,
etc.).
♦ Use a dry cloth to clean the housing.
♦ Use a brush to remove any dust stuck to the
appliance.
♦ Never use sharp objects, petrol, solvents or
cleansers which can damage plastic. Do not
allow any liquids to get into the interior of the
appliance.
NOTE
► Spare parts which are not listed (e.g. carbon
brushes, planing blades) can be ordered
exclusively via our Service Hotline.
and detach the drive
.
onto the small belt
.
and fix it in
.
regularly.
GB │ MT │
51 ■