Timex W-33 Manual De Instrucciones

THANK YOU FOR PURCHASING YOUR TIMEX WATCH.
EXTENDED WARRANTY
Available in U.S. only. Extend your warranty for an additional 4 years from date of purchase
for $5. You can pay with AMEX, Discover, Visa or MasterCard by calling 1 800-448-4639 during
normal business hours. Payment must be made within 30 days of purchase. Name, address,
telephone number, purchase date, and 5-digit model number required. You can also mail a
check for $5 to: Timex Extended Warranty, P.O. Box 1676, Dept. EF, Little Rock, AR 72203.
Please read instructions carefully to understand how to operate your Timex watch.
Your model may not have all of the features described in this booklet.
• Date and time display • Daily alarm • 24-hour countdown timer • Chronograph
Press MODE to cycle through CHRONO, ALARM, and TIMER modes. Press INDIGLO to illuminate
watch face. In any mode, press MODE to view time display. Press any button to stop alarm or
timer beeps.
A. Press and hold SET. HOURS digits will flash.
B. Press START/STOP or DATE to change hour digits. Go through 12 hours for AM or PM.
C. Press MODE to select MINUTES.
D. Press START/STOP or DATE to change.
E. Repeat to set MONTH, DATE, DAY, 12- or 24-hour time display, DAY-MONTH or MONTH-DAY
date display.
F. Press SET when done.
Press DATE to display date. Press again to display time.
A. Press MODE until CHRONO appears.
B. Press START/STOP to start.
C. Press DATE to view lap or split time. Display pauses for 7 seconds.
D. Press START/STOP to pause.
E. Press START/STOP to resume.
F. When timing is stopped, press and hold DATE to reset chrono.
A. Press MODE until ALARM appears.
B. Press and hold SET to select HOURS. Digits will flash.
C. Press START/STOP or DATE to change hour digits. Go through 12 hours for AM or PM.
D. Press MODE to select MINUTES.
E. Press START/STOP or DATE to change. Press SET when done.
F. Press START/STOP to turn alarm on or off.
When alarm time is reached, watch will beep and INDIGLO® display will flash for 20 seconds,
or until a watch button is pushed. Alarm will repeat every 24 hours until deactivated.
A. Press MODE until TIMER appears.
B. Press and hold SET to select HOURS. Digits will flash.
C. Press START/STOP or DATE to change digits.
D. Press MODE to select MINUTES. Press START/STOP or DATE to change.
E. Repeat to set SECONDS.
F. Press SET when done.
G. Press START/STOP to start timer.
H. Press START/STOP to pause, press again to resume.
I. When timer is stopped, press DATE to reset timer to the beginning.
J. Press and hold SET to set new countdown time.
Watch will beep when countdown ends.
INDIGLO® NIGHT-LIGHT WITH NIGHT-MODE® FEATURE
A. Press INDIGLO to activate light.
Electroluminescent technology used in the INDIGLO® night-light illuminates watch face at
night and in low light conditions.
B. Press and hold INDIGLO for three seconds (beep will sound) to activate or de-activate
NIGHT-MODE® feature.
C. While in NIGHT-MODE® feature, press any button to illuminate watch face for 3 seconds.
If your watch is water-resistant, meter marking or (
Water-Resistance Depth
30m/98ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER
WATER.
1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
www.timex.com
W-33
FEATURES
BASIC OPERATIONS
SET
MODE
TIME AND DATE
CHRONOGRAPH
indicates chrono is on.
ALARM
indicates timer is running.
WATER RESISTANCE
791-095003
indicates alarm is on.
TIMER
) is indicated.
p.s.i.a.* Water Pressure Below Surface
START/STOP
DATE
INDIGLO
60