Home2O H04L-821-CH Manual De Instrucciones

WIDE SPREAD BATHROOM FAUCET
H04L-821-CH – Polished chrome finish with pop-up
H04L-821-BN – Brushed nickel finish with pop-up
H04L-821-ORB – Oil rubbed bronze finish with pop-up
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A Spout assembly
B Handle assembly
C
D
E
F Rubber and metal washer
G
H
I Lift rod and knob assembly
J Pop-up assembly
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water supply
lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents. If any part is missing or
damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, thread sealant
tape, Silicone
Need Help? Please call our toll-free line at (877) 319-3757 (8 am to 5 pm CST) for additional assistance or service.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • www.homewerksww.com
QUANTITY
Washer
Nut
Bolt
Nut
Hose
1
2
2
2
4
1
1
1
1
1
CAUTION
• If you solder the joints during installation, the seats, cartridges, and washers
must be removed before using a flame or the warranty will be voided on
these parts.
• Cover the drain to avoid losing parts.
Installations may vary depending on how the previous faucet was
installed. Supplies necessary for the installation of the faucet are not
all included; however, they are available wherever plumbing supplies
are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn
on the old faucet to release built-up pressure. When installing the new faucet,
hand tighten the connector nuts. DO NOT OVERTIGHTEN. Connections
that are too tight will reduce the integrity of the system.
A
B
F
C
G
D
E
H
NSF 61
ADA
I
J
03-28-2018