Mounting Hardware - Uline H-7096 Manual Del Usuario

CAUTION! All electrical work should be
completed by qualified electrician and meet
all national, state and local codes.
WIRING
Fans come pre-wired with 120V three-prong power
cord:
• The power source must conform to the electrical
requirements of the fan.
• The power cord has a three-prong grounded plug
that must be plugged into a GFCI (Ground Fault
Circuit Interrupter) protected circuit.
• Do not alter the plug to remove the grounding
prong and never use a two-prong adapter.
• Replace damaged or worn power cords
immediately.
• Where possible, avoid using extension cords. If
one must be used, the cord must be UL listed, be
the proper size (Amp rating) and have three-prong
grounded connections.
Fans are not factory-wired (customer-supplied power
cord or hard-wired installations):
• Wiring should only be done by a trained electrician
to prevent injury or death.
• Configure internal wires to match supply voltage
and wire according to motor nameplate. Test to
verify correct rotation.
UNPACKING FAN
Inspect the unit for any damage that may have
occurred during shipping.
Contact Uline Customer Service at 1-800-295-5510
immediately if any damage is found.
NOTE: Wall mounts must be installed on a
support structure strong enough for the added
weight of the mount and fan assembly. User is
responsible for determining that their structure
is adequate to support these loads.
PAGE 2 OF 12
SAFETY CONTINUED
• Many of the electric motors are reversible. Ensure
fan is rotating in the proper direction. Blade must
spin clockwise when viewing the fan as shown with
the blade in front and motor in back.
(See Figure 1)
Figure 1
• Follow instructions on the motor label to change
rotation if necessary.
• It is recommended to install a lockable disconnect
switch near each fan.
• Route wire to motor with drip loop and secure. Drip
loop will drain accumulated moisture away from
motor.
• Only permit power to unit when motor cover plate
and all guards are properly installed to prevent
injury.
INSTRUCTIONS

MOUNTING HARDWARE

The hardware to attach the fan mount to the support
structure is not supplied. Hardware must be adequately
sized and be the proper type for installation to
safely support the fan. Always follow the fastener
manufacturer's installation instructions.
Blade Rotation
0821 IH-7096