6
The sponge should be replaced after about 18-24 months of use.
Over time the absorption capacity of the sponge may reduce
itself. Generally, with all humidification systems, it is highly
recommended to replace the sponge/polymers of any humidifier
periodically in order to prevent the creation of bacteria. The
oil of the Spanish cedar wood inside the humidor may cause
discolorations of the sponge, which are no reasons for concern.
You will not need to replace the whole humidifier, but only the
sponge, which can be purchased at a low price at many tobacco
stores.
4 Adjusting humidity level
The humidity level is set at 70% by the manufacturer. However you
can adjust this value based on your preference:
1
Press and hold the "Set" button for 3 seconds on the control
panel. Numbers will start to blink on the display. Press the " "
or " " button to raise or lower the humidity level, respectively.
2
The fan will turn on automatically once the humidity level drops
more than 1% below its pre-set value. The fan will turn off auto-
matically when the humidity level is 1% higher than its pre-set
value (e.g. if the pre-set humidity level is 70%, but the actual
humidity is 71%), and the fan will remain inactive until the actu-
al humidity drops more than 1% below its pre-set value once
again.
3
Pressing the "Set" button quickly will switch from °C to
Fahrenheit.
5
: Current humidity in humidor
: Current temperature in humidor
: Celsius or Fahrenheit temperature
: 3 day average humidity in humidor
: 3 day maximum or minimum humidity
: Showing water level in humidifier
: Visible when battery is low
© adorini - www.adorini.com