6
The sponge should be replaced after about 18-24 months of use. Over
time the absorption capacity of the sponge may reduce itself.
Generally, with all humidification systems, it is highly recommended to
replace the sponge/polymers of any humidifier periodically in order to
prevent the creation of bacteria. The oil of the Spanish cedar wood
inside the humidor may cause discolorations of the sponge, which are
no reasons for concern. You will not need to replace the whole humi-
difier, but only the sponge, which can be purchased at a low price at
many tobacco stores.
4 Adjusting humidity level
The humidity level is set at 70% by the manufacturer. However you can
adjust this value based on your preference:
1
Press and hold the "SET" button for 3 seconds on the control panel.
Numbers will start to blink on the display. Press the " " or " " button
to raise or lower the humidity level, respectively.
2
The fan will turn on automatically once the humidity level drops more
than 1% below its pre-set value. The fan will turn off automatically
when the humidity level is 1% higher than its pre-set value (e.g. if the
pre-set humidity level is 70%, but the actual humidity is 71%), and the
fan will remain inactive until the actual humidity drops more than 1%
below its pre-set value once again.
3
Pressing the "SET" button quickly will switch from °C to Fahrenheit.
5
: Current humidity in humidor
: Current temperature in humidor
: Celsius or Fahrenheit temperature
: 3 day average humidity in humidor
: 3 day maximum or minimum humidity
: Showing water level in humidifier
: Visible when battery is low
© adorini - www.adorini.com