Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
E-ACU, E-ACUH and E-ACS Series
FIGURE 2 - 2" (51 mm) Adjustable Fitter Positions
30˚
30˚
30˚
30˚
30˚
15˚
30˚
0˚
15˚
45˚
YOKE MOUNTING
Attach yoke to fixture as shown in Figure 3.
1.
NOTE: When installing sealing washers make sure the rubber side
is facing housing wall.
2.
Slide (2) lock washers over yoke bolts.
3.
Secure yoke to housing with (2) 5/16" nuts. Tighten nuts to 132
in-lbs (15 Nm).
4.
Insert cord thru cord grip so that the leads with the ground lug
extend from the threaded side of the cord grip by 4" or as needed
to reach ground lug in fixture. Tighten cord grip firmly to cord.
5.
Insert cord into fixture and fasten cord grip to housing as shown in
Figure 3.
6.
Connect cord ground wire to fixture ground. Connect cord
white wire to ballast common wire. Connect cord black wire to
appropriate ballast voltage tap wire.
NOTE: Use supplied 150°C wire nuts to make all electrical
connections within the fixture.
7.
Mount fixture using three 3/8" (10 mm) bolts appropriate for
mounting surface. See Figure 4a.
TO AIM FIXTURE:
1.
Remove #10-24 positioning screw.
2.
Loosen both 5/16-18 hex head bolts on sides of yoke.
3.
Rotate yoke to desired angle. Line up inner and outer yoke
positioning holes.
4.
Insert #10-24 screw into matching holes of inner and outer yokes,
and tighten.
5.
Retighten 5/16-18 hex head bolts.
NOTE: For typical sign light position See Figure 5.
Typical Pole Mounted Positions
Major Divisions: 15˚
75˚
90˚
180˚
www.e-conolight.com
Document:
CI308X30R2
Created By:
TMT
FIGURE 3 — YOKE MOUNTING
Adjustment Screw and Holes
Cord
Outer Trunion
FIGURE 4A –– MOUNTING TO SURFACE
FIGURE 4B –– MOUNTING TO FIXTURE
FIGURE 5 — TYPICAL SIGN LIGHT POSITION
12' (3.6 m)
|
888.243.9445
|
FAX: 262.504.5409
Date
ECO#
Align these Two Trunion Holes
Cord Grip
Sealing Washers
Lock
Washers
Hex Nuts
Lock Washer
between Trunions
Inner Trunion
(Assembles to the Housing)
Ø0.818"
(21 mm)
Hole
2.32"
(59 mm)
3.00"
(76 mm
)
3.57"
(91 mm
)
Ø0.175"
(30 mm)
Hole
Side View
Main Light Beam
2' (0.6 m)
5' (1.5 m
)
2016-5-02
006036
Hex Bolts
Housing
(Cross Section View)
2.00"
(51 mm)
Publicidad
Tabla de contenido
