Led Indicators - Tenda RX3 Guía De Instalación Rápida

LED indicators

LED indicator Status Description
The system is starting up, or the router is already
Solid on
connected to the internet.
Blink slow The router fails to connect to the internet.
Blink fast for
A device is connected to or disconnected from an
LED indicator
3 seconds
Ethernet port of the router.
Blink fast for The router is pending for or performing WPS
2 minutes negotiation.
The system is faulty, or the router is not powered
Off
on properly.
Jack, ports and buttons
Reset WPS WAN 1 2 IPTV/3 POWER
Jack/Port/
Description
Button
Power jack.
POWER Please use the included power adapter to connect this jack to a
power source for power supply.
Used to restore the factory settings of the router.
Method: When the router is working normally, hold the button
Reset
down with a needle-like object for about 8 seconds, and then
release it when the LED indicator blinks fast. The router is reset.
Used to start the WPS negotiation of the router.
Method: Press the button, and the LED indicator blinks fast.
WPS
Within 2 minutes, enable the WPS function of the other
WPS-supported device to establish a WPS connection.
10/100/1000 Mbps auto-negotiation WAN port.
WAN
Used to connect to a modem or the Ethernet jack using an
Ethernet cable for internet access.
10/100/1000 Mbps auto-negotiation LAN port.
1, 2
Used to connect to computers, switches or game machines, etc.
10/100/1000 Mbps auto-negotiation Ethernet port.
IPTV/3 It is a LAN port by default. When the IPTV function is enabled,
it can only serve as an IPTV port to connect to a set top box.
04