COLUMBIA VAC OPC1100 Manual De Instrucciones página 19

illumination . When the lock is on, the device settings cannot be changed or the
device cannot be switched off.
To disable the lock, hold down the extinguished button
'HUM' button - is used to set the humidity level.
Manual setting of humidity level is possible when program I or II is active. When program III
is enabled, the humidity level cannot be changed.
In order to set the humidity level, select program I or II and then press the butto
the display shows the desired value in the range of 20-80%.
If the humidity in the room is lower than the set humidity, the dehumidification function
will stop automatically – the fan will continue to operate.
The current humidity level is shown on the display.
Selecting any of the stored programs changes the humidity level settings.
'PURIFY' button
'TIMER' button
- is used to automatically switch on (delayed start) and switch off the
device.
Delayed start - this function allows you to set the time after which the humidifier will
-
start automatically.
The function can only be activated when the device is switched off, but connected to
the power supply.
The delayed start can be set between 1 and 24 hours by pressing the button
the desired value appears in the display.
Only full hours can be set.
Setting value '00' means that the settings are canceled.
Activation of the function is indicated by the button illumination
display.
After switching on the device with the button
Automatic shutdown - this function allows you to set the time after which the
-
humidifier will be shut down automatically.
The function can only be enabled when the device is turned on.
The automatic shutdown can be set between 1 and 24 hours by pressing the button
until the desired value appears in the display.
Only full hours can be set.
Setting value '00' means that the settings are canceled.
Activation of the function is indicated by the button illumination
After switching off the device with the button
'SLEEP' button
- enable/disable ni ght mode.
In this mode, the sound signaling is off and the fan operates only at low revolutions. Other
buttons are active.
- switching on/off the ionizer.
for a few seconds.
and digits on the
the time setting will be deleted.
.
the time setting will be deleted.
, until
until
19 EN