Emptying The Tank - COLUMBIA VAC OPC1100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 66
Indicator
- indicates that the water tank is full.
The indicator lights up red when the 2 liter capacity is reached.
The device will also indicate this with a sound, and then turn off.
Press any button to disable the sound alarm.
Then empty the water tank and put it back in the correct position.

EMPTYING THE TANK

ATTENTION
Water collected in the dehumidifier tank is not suitable for drinking and must not be
allowed to come into contact with food.
Do not put the floater out of water; otherwise the device will not stop working when
the water tank fills up. Then, water will overflow, which may cause damage to the
floor.
Pull the tank gently at the back of the device; the tank will slide out.
Pour the water out of the tank.
If the water tank is dirty, clean it with water. Do not use any acrid cleaning agents. Do not
use chemical solvent (such as benzene, alcohol, gasoline). The surface may be damaged or
even the whole case may be deformed. Do not sprinkle water
Place the tank in the right position in the device. Otherwise, the full tank indicator will still
light up red and the device will not be able to work.
CONTINUOUS WATER OUTLET (fig. 6).
In order to use the device with the continuous water outlet connected, you should:
-
Remove the water tank.
-
Remove the tank housing component.
-
Slide a pipe to the water outlet valve located in the upper section of the tank bay.
-
Slide the tank in and lead the pipe out through the cut-out.
-
Place the other end of the pipe into a container, e.g. a bucket.
ATTENTION
Never bend the drain tube. The tube outlet must always be below the water outlet
from the device. Never block the water outlet from the device or the tube.
MAINTENANCE
Note:
Turn off the unit and unplug it before any maintenance or repair begins to avoid electric
shock.
CLEANING
Unplug the unit before any cleaning. Clean the housing with a soft moisture cloth. Do not
use chemical solvent (such as benzene, alcohol, gasoline). The surface may be damaged or
even the whole case may be deformed. Do not sprinkle water on the unit.
20 EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido