Getting Started; Helpful Hints; Care & Cleaning - Twin-Star International 33WM684 Manual De Instrucciones

1. Before assembly, CAREFULLY use scissors or utility knife to cut and unwrap all parts. MAKE SURE YOU DO
NOT DISCARD THE HARDWARE.
2. Make sure that you have all the parts listed. If you are missing any parts please email Customer Service:
parts@twinstarhome.com, or call 1-866-661-1218. Please identify the parts you need, and model number.
Include your name and address.
• Some steps are more easily handled with two adults.
• Attach the fireplace insert to the completed wood mantel last. INSTALL INSERT IN FROM THE BACK OF THE
FIREPLACE SO AS NOT TO SCRATCH THE HEARTH/BASE.
• Use care in assembling your new fireplace, take your time and use the hardware provided and a quality Phillips
head screwdriver. NEVER OVER TIGHTEN BOLTS.
• Wood Glue is supplied with your fireplace and its use is included in the step-by-step instructions. Use of the
glue is optional, if you will be moving the fireplace in the future you may wish to leave these steps out. This
allows you to easily disassemble your fireplace. If you are using the glue we suggest a complete "dry" fitting
prior to the application of the glue.
1. Dust your fireplace regularly with a soft non-lint producing cloth or household dusting product.
2. You can clean your fireplace with a gentle non-abrasive household cleaner. Make sure to dry
your fireplace immediately with a soft cloth or towel.
For a complete tight fit every bolt
should have a flat washer. First slide
a flat washer onto the bolt. Your bolt
is now ready for use.
Now it is time to assemble your fireplace.
All panels are labeled Left and Right as viewed
from the front of unit.
1. Locate the Center Front Panel (D), Right
Front Panel (C), and Left Front Panel (B) and
set out face down on a scratch free surface.
2. Place a drop of Wood Glue (O) into each of
the pre-drilled holes on the edges of the
Center Front Panel (D). Then insert one
Wood Dowel (N) into each of the pre-drilled
holes.
3. Push the Right Front Panel (C) and Left Front
Panel (B) snug to the Center Front Panel (D).
Make sure the Wood Dowels are seated in the
pre-drilled holes. Insert Bolt (L) and Washer
(M) into the pre-drilled holes in the mounting
blocks. HAND TIGHTEN ONLY.
E-2
PLEASE READ AND FOLLOW ALL SAFETY TIPS

GETTING STARTED

HELPFUL HINTS

CARE & CLEANING
L
N
D
Center Panel
Right
Front
C
Panel
N
M
Left
B
Front
Panel