ulixes 350 Instrucciones página 10

Attention!
•
This manual is for qualified installers only and not for the end user. It is the installer's job to
explain to the user how the automatism works, about possible hazards related to it and
the need for periodical maintenance.
•
Installation must be carried out by qualified personnel only, in compliance with current
standards concerning automatic closing mechanisms.
•
ULIXES is made specifically to control the automation of swing gates and therefore it is
forbidden to use it for any other purposes or improperly.
•
Use original components only. Stagnoli is not liable for damages if any other components
are used.
•
Make sure that the gate structure is solid and suitable to be motorised.
•
Make certain that when the gate is moving there are no points of friction and there is no
chance of it derailing.
•
Make absolutely certain the power is disconnected before carrying out any work on the
device.
•
Connect the power lead only to supply lines with adequate electrical protection.
•
Be particularly careful when evaluating the safety devices to install and their location.
Always install an emergency stop device that will cut power off in the case of necessity.
•
The irreversible gearmotor avoids installing an electric lock and in case of black-out the
release with personal single key allows the gate to be easily opened and closed.
Nevertheless the electronic lock should be installed to assure a better closing above all
by wings longer than 2.5 meters.
Istruzioni , Instructions, Betriebsanleitung, , Instrucciones
10