Task 4: Creating Your Logical Drive - Promise Technology FASTTRAK TX4660 Guia De Inicio Rapido

FastTrak TX4660, TX8660, TX8668 Quick Start Guide

Task 4: Creating Your Logical Drive

The following instructions apply to the FastTrak TX4660 and TX8660 cards. This
task uses the onboard FastBuild BIOS utility to create a logical drive with directly
attached disk drives.
For an explanation of the logical drive concepts, see Chapter 6 of the TX4660,
TX8660, TX8668 User Manual on the CD.
1. Boot your system. If this is the first time you have booted with the FastTrak
card and drives installed, the Promise onboard BIOS will display the
following screen (below).
The FastBuild utility and WebPAM software do NOT support the
VessRAID subsystem.
Use the embedded applications on the VessRAID. See page 11.
You can omit this step, proceed with the WebPAM installation on
page 16, then create your logical drive using WebPAM. For more
information, see Chapter 5 of the FastTrak TX4660, TX8660,
TX8668 User Manual on the CD.
Caution
Note
12