goliath R-AC008 Manual Del Usuario

EN
GOLIATH R-AC008
USER'S MANUAL
UPPER DOCKING BLOCK FOR G2 STANDS
YOU WILL FIND IN THE BOX:
1 Upper docking block top mounted
1 M6 Allen screw
DESCRIPTION AND TECHNICAL FEATURES:
The R-AC008 upper docking block was primarily designed to work in conjunction with
the R-AC009 lower docking block on the back of the G2 line stands (manual stands).
Its purpose is to house the axles for wheel work (included in the R-AC002 set)
or the fork for quick-change wheels (R-AC003), allowing the wheel to be
worked on to be positioned on the upper part of the stand (Example: Photo 3).
However, it is also possible to insert any clamp from the GOLIATH BIKE line and
thus use two workstations on the same G2 stand, front and rear.
This docking block is compatible exclusively with the following stands:
- GOLIATH EVOLUTION (G2-EVO)
- GOLIATH RACE (G2-RACE)
- GOLIATH MANUAL (G2)
ASSEMBLY AND USE INSTRUCTIONS:
1- Insert the block from bottom to top as shown in photo 1 by tting the side
pivots.
2- Tighten the Allen screw after inserting it in the central part from top to
bottom. (Photo 1)
3- Once installed you can attach the accessory you need for the tasks to be
performed, either wheel axles or a 360º clamp.
*In case of working together with the lower docking block R-AC009 it is
necessary to position the latter about 40cm from the center of the upper
docking block R-AC008. (Photo 2)
WARNINGS OF DANGER IN THE USE:
1- This accessory must not be operated by children.
2- Secure the docking block well by tightening the Allen screw to avoid an
accidental fall.
1
MAINTENANCE:
This accessory does not require any speci c maintenance, however the docking
adjustment handle can be lubricated with oil for smoothness.
2
3
WWW.GOLIATH-BIKE.COM