goliath G2 Manual Del Usario

ES
GOLIATH MANUAL
USER'S MANUAL
YOU WILL FIND IN THE BOX:
1 GOLIATH G2 support body assembled.
1 clamp 360º BASIC
1 clip to x the clamp
4 8mm lag screws with 4 10mm plastic dowels
3 tube legs 40x40 mm
1 base plate for mounting legs
6 hexagon socket head cap screws m-8
4 adjustable leg plugs
2
1
1
GOLIATH 360º BASIC CLAMP
2
CLAMP PRESSURE
3
SIDE LOOP
4
UP/DOWN HANDLE
DESCRIPTION AND TECHNICAL FEATURES:
Bicycle repair stand with manual height adjustment.
Manual up/down control
Minimum height of the clamp: 700mm
Maximum height of the clamp: 1.300mm
Maximum weight to be supported: 30kgs
G2
ASSEMBLY INSTRUCTIONS:
MOUNTING THE CLAMP ON THE STAND:
1- Remove the washer from the back of the clamp by unscrewing
the Allen screw, insert the back of the clamp into the clamp
holder. (Photo 1)
2- Mount the clamping lever [3] on the right side of the clamp
holder and x the clamp with it so that it does not rotate.
3- Replace the washer on the back of the clamp and x the Allen
screw to prevent the clamp from accidentally falling. (Photo 2)
The clamp is now mounted and can roll freely once the side
handle [3] of the clamp holder is loosened and xed by
tightening the clamp.
Photo 3
3
4
INSTALLATION AND FIXING OF THE STAND:
The stand has three ways to be xed: To the oor by means of screws (Photo 3), by means of legs (Photo 4) or by xing it to the at
base (Photo5).
*The rectangular at base (G-P2) is sold separately.
1 - To x the stand directly to the oor (Photo 3), in the package you will nd the plugs and screws necessary for the operation,
taking into account the state of the oor to which you want to x the stand.
2 - To assemble the legs (Photo 4) you have to use the sheet metal base that goes in the box, this has the threaded holes so it does
not need nuts.
The legs are 3 tubes of 40 x 40 mm that are included as part of the stand. They are equipped with height regulating blocks. (Photo 4)
Photo 1
Photo 4
Photo 2
Photo 5