Connecting To The Tv - Samsung SEK-2000 Manual De Instrucciones

Inserting Batteries into the Samsung Smart Control
To use Samsung Smart Control, first refer to the figure below and insert batteries into the unit.
- We recommend using Samsung Smart Control at a distance of less than 6m. A usable distance may differ depending on the wireless
environmental conditions.

Connecting to the TV

Press the TV button on the Samsung Smart Control to turn on the TV. The Samsung Smart Control connects to the TV automatically. If this is the
first time you have turned on the TV, the Initial Setup screen appears. Follow the directions on the screen to set up the TV.
- To finish installing the Evolution Kit on 2012 TVs, re-pair the previously used 2012 IR Blaster by pressing the PAIRING button on the
bottom of the IR Blaster. For a detailed explanation, refer to the TV's user manual.
Reconnecting the Samsung Smart Control
If the Samsung Smart Control stops operating or works abnormally, replace the batteries as this may be due to insufficient battery power.
If the problem persists, the Samsung Smart Control restores pairing with the TV.
1. Press RETURN button and GUIDE button simultaneously for 3 seconds.
- You must place the Samsung Smart Control approximately 30cm ~ 40cm away from the TV and ensure it is pointing towards the
remote control receiver.
2. Connection image is appeared on the screen. And then, Samsung Smart Control is connecting to TV automatically.
Gently pull on the battery cover's notch and then remove the cover completely once it comes
1
loose.
Insert 2 AA alkaline batteries, making sure to align the positive and negative polarities correctly.
2
Place the battery cover on the remote control and insert the top part of the cover into the
3
remote control.
Press the catches on both sides of the battery cover in the order shown so that the cover is
4
completely attached to the remote control.
English-6