Adjusting The Gmos-Lan-09; Important - Axxess GMOS-LAN-09 Instrucciones De Instalación

Ocultar thumbs Ver también para GMOS-LAN-09:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjusting the GMOS-LAN-09

AX-LCD adjustment
• Press and hold the "Return/ESC" button on
the LCD screen for 5 seconds until "Select
Interface" comes up.
• Select "Connection Type", and then press "Enter"
• Scroll up or down to "Gateway", and then
press "Enter"
• Once done, press the "Return/ESC" button
two times to get back to the main menu.
Chime Volume Adjustment
• With the vehicle on, turn it off and leave the
key in the ignition. Open the driver's door;
chimes will be heard.
• Wait 10 seconds, and then with a small
flat-blade screwdriver, turn the potentiometer
clockwise to raise the chime level;
counterclockwise to lower the chime level.
Note: The potentiometer is located on
the side of the interface where the 16-pin
harness with stripped leads is connected to.
METRA. The World's best kits.
Installation instructions for GMOS-LAN-09
Chime Volume Adjustment (continued)
• When the chime level is at a desired level,
remove the key from the ignition. This will
lock the chime volume at its current level.
OnStar Level Adjustment
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME
UP or VOLUME DOWN buttons on the steering
wheel to raise or lower the OnStar level.
OnStar Level Adjustment
• If the vehicle does not come equipped with
steering wheel controls, find the Black/
Yellow wire on the 22-pin harness.
• While OnStar is speaking, tap the Black/
Yellow wire to ground. Once the OnStar level
is set, it will stay at that level until the Black/
Yellow wire is tapped to ground again.
metraonline.com

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido