Safety And Protective Devices; Electrical Requirements; Mains Connection; Mains Cable - AL-KO Easy Crush MH 2810 Manual Del Usuario

GB
Symbol Meaning
Wear gloves.
3.5

Safety and protective devices

WARNING! Risk of injury. Defective and
disabled safety and protective devices can result
in serious injury.
■
Have any defective safety and protective de-
vices repaired.
■
Never disable safety and protective devices.
Motor protection switch
The motor protection switch disconnects in the
case of overload. Hereby, switch (06/3) pops out
of the control panel. The switch can be pushed
back in again after a cooling-down phase of ap-
prox. 5 minutes, and the machine can be
switched on. If the switch does not remain by it-
self in the pressed position, extend the cooling-
down phase. If the problem continues to exist,
take the machine to a specialist workshop.
Restarting protection
For your safety, the machine is fitted with a 0
voltage switch, which automatically switches off
the machine in the case of a power interruption.
Once the voltage supply is re-established, the
machine does not restart automatically. Press the
ON switch (06/1) to restart.
Protection switch on the shredder upper
section (MH 2810)
The shredder upper section is equipped with a
protection switch, which switches off if the locking
screw (01/2) is loosened. The motor is thus pre-
vented from unintentional starting.
The machine can only be switched on again
when the shredder upper section (01/11) has
been fitted and the locking screw tightened.
20
3.6

Electrical requirements

3.6.1

Mains connection

DANGER! Risk of electric shock if the log
splitter is operated without residual current
circuit breaker. Operation of the appliance with-
out residual current circuit breaker in the mains
connection can result in serious injuries or even
death due to electric shock.
■
Before connecting the appliance, check
whether the mains connection has a residual
current circuit breaker for a maximum leak-
age current of 0.03 A.
■
If you cannot be sure that a residual current
circuit breaker is installed: Use an additional
portable residual current device with switched
PE conductor.
■
Mains voltage, see "Technical data". Do not
use any other mains voltage!
Only for Great Britain (240 V)!
■
This machine must be earth!
■
Never use a faulty power cable!
■
Check the power cable regularly for signs of
wear and tear!
Wiring instructions:
When wiring the English 3 pin plug, please follow
the instruction according to the colour coding as
shown below:
Green and yel-
low to termi-
nal
Brown to ter-
minal
Blue to termi-
nal
3.6.2

Mains cable

WARNING! Risk of injury from electric
shock. A defective mains cable can result in seri-
ous injuries due to electric shock.
■
Make sure that the mains cable is not dam-
aged or severed.
Product description
E Earth
L Live
N Neutral