Cleaning And Maintenance - Bimar Eco Panel S580.EU Folleto De Instrucciones

Fax +32 030 9904733
• The heater should be installed 20cm to 100cm from the floor for best performance.
• Kit wall mounted (included inside the box): 1 x Drill Bit (8mm), 4 x Plastic Mounting Lugs, 4 x
Fastening Bolts, 4 x Caps for Bolts.
• If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-resistant
material (not of wood or synthetic material which rapidly heats up), care should be taken not to fit
panels where water pipes or electrical wiring might be embedded in the walls; follow the
indications below for installation:
- Use the holes provided in the carton/polystyrene packaging for make two holes in wall 73,6cm.
apart, perfectly horizontal; insert plastic mounting lugs, fastening bolts and the caps.
• Warning: don't use wet hand touch the working machine and don't cover the wind outlet and inlet.
• Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
USE
Each time before use, check that the appliance is in good state, that the electric cord is not damaged:
in case of doubt, do not use it but contact a qualified technician.
When using for the first time
Attention: to operate the panel heater, to eliminate the "new smell" and any residual oils for
processing at least a few hours. During this operation, ventilate the area in order to eliminate the smell
"new" that emanates from the panel.
To use the panel heater, act as follows:
1) Insert the plug into the socket.
2) Switch on the main switch (pos."I").
3) At the end of use, completely switch off the appliance using the main switch (pos."0") located on
the side.
For long periods of inactivity, remove the plug from the power socket.

CLEANING AND MAINTENANCE

Attention: before cleaning the appliance, switch off, unplug and wait for before it has
completely cooled down.
• To clean the body use a soft damp cloth; do not use abrasive products.
• Do not submerge any part of the heater in water or other liquids; if this should happen, do not
put your hands into the liquid, firstly remove the plug from the power socket. Carefully dry the
appliance and check that all the electrical parts are dry: if in doubt, contact professionally
qualified personnel.
• If you decide not to use the appliance any more, we recommend making it inoperative by
cutting the power cord (after making sure you have disconnected the plug from the socket) and
make dangerous parts harmless if children are allowed to play with them.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
10/28
Assembly page 10/28