General Advice - Bimar Eco Panel S580.EU Folleto De Instrucciones

Panel radiante termico, teñido
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Fax +32 030 9904733
T
symbol invites you to read these instructions carefully before using the
his
appliance, and also inform third parties of them, if necessary.
booklet for future reference and for the entire lifetime of the device. If any parts
of these instructions prove difficult to understand or if in doubt, contact the
company at the address written on the last page before using the product.
WARNING!
T
his symbol highlights instructions and warnings for safe use.
T
his symbol: indicates that the appliance is Class II.
T
his symbol show: WARNING: In order to avoid overheating, do not
cover the heater.
T
his symbol indicates the high-low position: must be installed so that the switch is in the
upper right. To ensure the functioning so safely and correctly, must be installed so that the
switch is in the upper right.

GENERAL ADVICE

T
his appliance is destined only to the heating of internal domestic or similar environments and in
compliance with these instructions. It can be considered only a supplementary source of heating
and not as a central heating element.
T
his appliance is intended to be used in household and similar applications such as:
-
staff kitchen in shops, offices and other working environments;
-
farm houses
-
by clients in hotels, motels and other residential type environments
-
bed and breakfast type environments
T
he appliance must not be used in dusty environments, in the presence of inflammable products,
or out of doors in the open. Any other use is to be considered inappropriate and therefore
dangerous. The manufacturer cannot be held responsible for eventual damage caused by
inappropriate, improper or irresponsible use and/or for repairs made to the product by unauthorised
personnel.
T
he front of the heater can be painted to match your décor. Only use acrylic water-based domestic
paint (do not use oil-based paints). Allow the paint to dry before switching the heater on
(approximately 12–24 hours).
T
he heater panel gets hot when working; so only touch the switch. Avoid contact with the area.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
7/28
Assembly page 7/28
Store
this

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Eco panel cph-09

Tabla de contenido